Error message

Tool radius too large

Cause of error

- Contour milling: The radius of an arc block at an inside corner is smaller than the tool radius.
- Thread milling: The thread core diameter is smaller than the tool diameter.
- Slot milling: The slot width for roughing is smaller than the tool diameter.
- Cycle 251, rectangular pocket: The rounding radius Q220 is smaller than the tool radius.
- Cycle 214: The given workpiece-blank diameter is smaller than the tool diameter

Error correction

- Use a smaller tool
- Slot milling: If necessary, use a smaller oversize (Q368)
- Cycle 214: Use a smaller tool; correct the workpiece-blank diameter