Unknown device on SPI bus (%1)
Cause of error
The NC software identifies every connected devices by means of a device table.
The table indicates whether the device is supported by the software version installed on the control.
A device that the software does not support or that is not yet entered in the device table is connected with the SPI bus.
The device concerned is indicated in the additional information.
- Inform your service agency.
- Run an update of the NC software if the device is not supported by the currently installed version of NC software.
- Update the device table. A new device that is not yet listed in the device table might be supported by the installed software. In this case an update of the device table is required.