Error message

1800F Error in EnDat motor encoder %1, error code %4

Cause of error

- The EnDat motor encoder reports an error
- The error code describes the cause:
1 = Failure of the illumination
2 = Incorrect signal amplitude
4 = Incorrect position value
8 = Overvoltage in the power supply
16 = Undervoltage in the power supply
32 = Overcurrent
64 = Battery exchange needed

Error correction

- Check the installation of the encoder
- Check the power supply of the encoder
- If required, exchange the battery
- Exchange the encoder
- Inform your service agency.