Program Continuation:

Profibus DP: no output slot available for base address %1 (size %2)

%1 = Logical base address of the requested area %2 = Size of the area in bytes

An incorrect logical base address was specified for a digital or analog input. Either no slot has been configured for this base address or the requested area extends beyond the end of the slot.

For length =1 it is a digital output,

For length =2 it is an analog output.

-    Channel not ready.

-    NC Start disable in this channel.

-    Interface signals are set.

-    Alarm display.

Enter correct base addresses in the machine data:

For length=1: Correct machine data MN_HW_ASSIGN_DIG_FASTOUT.

For length=2: Correct machine data MN_HW_ASSIGN_ANA_FASTOUT.

NCK restart

If the error cannot be eliminated by this procedure, please make a note of the error text and contact the control system manufacturer.

Switch control OFF - ON.


© Siemens AG 2005 All Rights Reserved