Remedy:
Program Continuation:
Axis %1 drive %2 D component of force controller invalid
%1 = NC axis number %2 = Drive number
The D component of the force controller MD 5246: FORCECTRL_DIFF_TIME is too high.
- NC not ready.
- The NC switches to follow-up mode.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
- Channel not ready.
Enter a smaller value for the D component of the force controller MD 5246: FORCECTRL_DIFF_TIME.
Clear alarm with the RESET key in all channels. Restart part program.
© Siemens AG 2005 All Rights Reserved