Remedy:
Program Continuation:
Axis %1 drive %2 proportional gain of force controller too high
%1 = NC axis number %2 = Drive number
The P gain of the force controller MD 5242: FORCECTRL_GAIN is too high.
- NC not ready.
- The NC switches to follow-up mode.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
- Channel not ready.
Enter a smaller value for the P gain of the force controller MD 5242: FORCECTRL_GAIN. Clear alarm with the RESET key in all channels. Restart part program.
© Siemens AG 2005 All Rights Reserved