Remedy:
Program Continuation:
Axis %1 drive %2 proportional gain for speed controller too high
%1 = NC axis number %2 = Drive number
The P gain of the speed controller is too high:
Modify MD 5406: SPEEDCTRL_GAIN_A (gain on A-side of cylinder edge) or MD 5407: SPEEDCTRL_GAIN (gain for piston adjustment with lowest natural frequency)
or MD 5408: SPEEDCTRL_GAIN_B (gain on B-side of cylinder edge)
- NC not ready.
- The NC switches to follow-up mode.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
- Channel not ready.
Enter a smaller value for the P gain of the speed controller:
Modify MD 5406: SPEEDCTRL_GAIN_A (gain on A-side of cylinder edge) or MD 5407: SPEEDCTRL_GAIN (gain for piston adjustment with lowest natural frequency)
or MD 5408: SPEEDCTRL_GAIN_B (gain on B-side of cylinder edge)
Clear alarm with the RESET key in all channels. Restart part program.
© Siemens AG 2005 All Rights Reserved