Remedy:
Program Continuation:
Axis %1 drive %2 distance-coded scale incorrectly parameterized
%1 = NC axis number %2 = Drive number
If a distance-coded scale is selected (MD 5011 bit 7=1) a length measuring system must also be configured (MD 5011 bit 4=1).
- Mode group not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Check and, if necessary, correct MD 5011: ACTUAL_VALUE_CONFIG (actual value sensing configuration).
Switch control OFF - ON.
© Siemens AG 2005 All Rights Reserved