310708

Parameters:

Definitions:

Reactions:

Remedy:

Program Continuation:

Axis %1 drive %2 number of encoder marks of measuring system invalid

%1 = NC axis number %2 = Drive number

The number of encoder marks of the motor measuring system in the drive MD 5005: ENC_RESOL_MOTOR (number of encoder marks of the motor measuring system) is zero or greater than the maximum input limit.

-    NC not ready.

-    The NC switches to follow-up mode.

-    Channel not ready.

-    NC Start disable in this channel.

-    Interface signals are set.

-    Alarm display.

-    NC Stop on alarm.

Match the number of encoder marks of the motor measuring system in drive MD 5005: ENC_RESOL_MOTOR (number of encoder marks of the motor measuring system) to the encoder in use. (Default setting for motor measuring system: (Default setting for motor measuring system: 2048 incr./rev.).

Switch control OFF - ON.

1-2733

© Siemens AG 2005 All Rights Reserved