Axis %1 drive %2 STS configuration of axes differ

%1 = NC axis number %2 = Drive number

The configuration of the control block MD 5003: STS_CONFIG (STS configuration) must be identical for both axes on 2-axis modules.

-    NC not ready.

-    The NC switches to follow-up mode.

-    Channel not ready.

-    NC Start disable in this channel.

-    Interface signals are set.

-    Alarm display.

-    NC Stop on alarm.

Check drive MD 5003: STS_CONFIG (STS configuration) and set the bits for the two axes of the module so that they are the same. (Do not change the default setting - this corresponds to the optimum configuration).

Switch control OFF - ON.

© Siemens AG 2005 All Rights Reserved