310612

Parameters:

Definitions:

Reactions:

Remedy:

Program Continuation:

Axis %1 drive %2 force limitation off

%1 = NC axis number

%2 = Drive number

The force limitation is deactivated.

Cause:

The force limitation is deactivated but:

The NC has defined a force limit or Travel to fixed stop is selected.

-    Mode group not ready.

-    The NC switches to follow-up mode.

-    Channel not ready.

-    NC Start disable in this channel.

-    Interface signals are set.

-    Alarm display.

-    NC Stop on alarm.

-    Channel not ready.

Activate power limitation: Modify MD 5241: Set bit 0.

Clear alarm with the RESET key in all channels of this mode group. Restart part program.

1-2725

© Siemens AG 2005 All Rights Reserved