Program Continuation:

Axis %1 drive %2 fixed link voltage of axes differ

%1 = NC axis number %2 = Drive number

An unequal fixed voltage MD1161: $MD_FIXED_LINK_VOLTAGE (DC link fixed voltage) has been found for axes of a drive module. Since a fixed voltage <> 0 replaces the measured DC link voltage value, but the DC link voltage value is measured only once for all axes of a drive module, the fixed voltage must be identical on all module axes before it is accepted.

The alarm can be reprogrammed in the MD ALARM_REACTION_CHAN_NOREADY (channel not ready).

-    NC not ready.

-    The NC switches to follow-up mode.

-    Channel not ready.

-    NC Start disable in this channel.

-    Interface signals are set.

-    Alarm display.

-    NC Stop on alarm.

-    Channel not ready.

Please inform the authorized personnel/service department. Set the same fixed voltage (MD 1161) on all module axes. $MD_FIXED_LINK_VOLTAGE (DC link fixed voltage) has been found for axes of a drive module.

Clear alarm with the RESET key in all channels. Restart part program.

© Siemens AG 2005 All Rights Reserved