Reactions:
Remedy:
Program Continuation:
%1 = NC axis number %2 = Drive number
Check and, if necessary, correct MD 1300: $MD_SAFETY_CYCLE_TIME (monitoring cycle) has not been set as a multiple of the NC position control cycle.
Request: During boot-up of the control.
- Mode group not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Please inform the authorized personnel/service department. Set the monitoring cycle via MD 1300 to n * NC position control cycle, n must be >= 1.
Switch control OFF - ON.
© Siemens AG 2005 All Rights Reserved