300743

Axis %1 drive %2 function not supported on this 611D controller module

Parameters:

%1 = NC axis number

%2 = Drive number

Definitions:

The 611D Performance control module is required for SINUMERIK Safety Integrated. If this hardware has not been installed, this alarm is triggered. The alarm also occurs if 1PH2/4/6 motors are connected and no 611D performance control module is available. The following function is not supported in connection with 611D Comfort modules: Motor switchover (MD1013 >0) and MD1100 not equal to MD2100.

Safety Integrated: Booting is interrupted, the pulses remain disabled. The 611D Performance control module is required for SINUMERIK Safety Integrated. If this hardware has not been installed, this alarm is triggered. This alarm is also triggered if the motors 1PH2/4/6 are connected and no 611D Performance control module has been installed.

Reactions:

Request: During boot-up of the control.

-    Mode group not ready.

-    Channel not ready.

-    NC Start disable in this channel.

Remedy:

Program Continuation:

-    Interface signals are set.

-    Alarm display.

-    NC Stop on alarm.

Replace the 611D control module.

Switch control OFF - ON.