Remedy:
Program Continuation:
Axis %1 drive %2 module number for measuring system not possible
%1 = NC axis number %2 = Drive number
The NC has assigned the direct measuring system to an axis which doesn't have a motor measuring system. This error can only occur with the 810D!
- NC not ready.
- The NC switches to follow-up mode.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Please inform the authorized personnel/service department. Check the configuration of the direct measuring system. See NC-MD 30220: $MA_ENC_MODULE_NR and NC-MD 30230: $MA_ENC_INPUT_NR.
Switch control OFF - ON.
© Siemens AG 2005 All Rights Reserved