Reactions:
Remedy:
Program Continuation:
Axis %1 drive %2 position controller cycle times of axes differ
%1 = NC axis number %2 = Drive number
In a 2-axis module, the position controller cycle for the two axes is not the same. This alarm can only occur with OEM users having the 611D drives without the standard NCK interface. This would make it possible to transfer axially different position controller cycles to the 611D module.
- NC not ready.
- The NC switches to follow-up mode.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Please inform the authorized personnel/service department. Set an identical position controller cycle for both axes.
Switch control OFF - ON.
© Siemens AG 2005 All Rights Reserved