300709
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
Axis %1 drive %2 speed controller cycle times of axes differ
%1 = NC axis number %2 = Drive number
The speed controller cycle MD 1001: $MD_SPEEDCTRL_CYCLE_TIME must be identical for both axes on 2-axis modules.
- NC not ready.
- The NC switches to follow-up mode.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Please inform the authorized personnel/service department. Reduce speed controller cycle MD 1001: $MD_SPEEDCTRL_CYCLE_TIME must be identical for both axes on 2-axis modules.
Switch control OFF - ON.
1-2588
© Siemens AG 2005 All Rights Reserved