Axis %1 drive %2 base cycle time invalid

%1 = NC axis number %2 = Drive number

The base cycle time set on the NC was too high for the drive.

-    NC not ready.

-    The NC switches to follow-up mode.

-    Channel not ready.

-    NC Start disable in this channel.

-    Interface signals are set.

-    Alarm display.

-    NC Stop on alarm.

840D: NCK RESET. After powering up the system again, the NCK machine data 10 050: $MN_SYSCLOCK_CYCLE_TIME (system base cycle) and MD 10080: $MD_SYSCLOCK_SAMPL_TIME_RATIO (division factor of position control cycle for actual value acquisition) are also modified automatically so that the limits are respected. 840C: Change the base cycle on the NC in MD 168.

Switch control OFF - ON.

© Siemens AG 2005 All Rights Reserved