Remedy:
Program Continuation:
Axis %1 drive %2 unknown drive alarm, code %3
%1 = NC axis number %2 = Drive number %3 = Service number
The service number signaled by the drive is not implemented in the NCK. It cannot be assigned to any alarm number.
- Mode group not ready.
- The NC switches to follow-up mode.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Please inform the authorized personnel/service department. Reinitialization of the drive required.
The search for the precise cause of error can only be performed by the development team. The displayed error codes are always needed for this. (contact SIEMENS AG, System Support for A&D MC products, Hotline (Tel.: see alarm 1000).
Clear alarm with the RESET key in all channels of this mode group. Restart part program.
© Siemens AG 2005 All Rights Reserved