Remedy:
Program Continuation:
Axis %1 drive %2 hardware version of control module not supported
%1 = NC axis number %2 = Drive number
There is a drive module with an "old" control module on the drive bus. 810D does not support these modules. Ramp-up is interrupted.
- NC not ready.
- The NC switches to follow-up mode.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Please inform the authorized personnel/service department. Order standard or performance control module and exchange with "old".
Switch control OFF - ON.
© Siemens AG 2005 All Rights Reserved