Remedy:
Program Continuation:
Axis %1 drive %2 hardware version of spindle not supported
%1 = NC axis number %2 = Drive number
An old spindle power section (so-called 186-HSA) is connected to the drive bus. This spindle drive is not supported by SINUMERIK 840D. Ramp-up is interrupted.
- NC not ready.
- The NC switches to follow-up mode.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Please inform the authorized personnel/service department. A DSP spindle module must be ordered and fitted.
Switch control OFF - ON.
© Siemens AG 2005 All Rights Reserved