300002
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
Axis %1 drive number %2 assigned twice
%1 = NC axis number %2 = Drive number
The drive logic number in the NCK MD 13010 DRIVE_LOGIC_NR has been assigned more than once.
- NC not ready.
- The NC switches to follow-up mode.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Please inform the authorized personnel/service department. Check MD 13010 DRIVE_LOGIC_NR for identical drive logic numbers and assign another number in the range between 0 and 15 (0 corresponds to "No drive available" and is the only number that may occur more than once in the MD array) to each drive.
Switch control OFF - ON.
1-2521
© Siemens AG 2005 All Rights Reserved