Reactions:
Remedy:
Program Continuation:
Communication failure
The operator panel is connected with the NC and PLC via a serial bus.
This alarm occurs when the communication to these components is interrupted.
In connection with this alarm, all display values connected with the NC/PLC become invalid.
Such faults are normal while the controls are ramping up (e.g. after resetting).
- Alarm display.
The alarm disappears automatically as soon as the fault situation has ended.
If this alarm is continuously present, a wide variety of faults may be the cause. (e.g. wire breakage, NC/PLC not ramped up,
faulty address/data transfer rate configuration of one of the bus nodes, etc.).
Internal
© Siemens AG 2005 All Rights Reserved