61243

Parameters:

Definitions:

Reactions:

Remedy:

Program Continuation:

Channel %1 block %2: Correct tool change point, tool tip in

%1 = Channel number %2 = Block number, label

The tool change point must be situated so far outside the retraction area that no tool protrudes into the retraction area on turret swivelling.

Alarm triggered by following cycle: F_SP_RP

-    Interpreter stop

-    NC Start disable in this channel.

-    Interface signals are set.

-    Alarm display.

Specify another tool change point.

Clear alarm with the RESET key. Restart part program

1-1409

© Siemens AG 2005 All Rights Reserved