Remedy:
Program Continuation:
Channel %1 Block %2: Feed/tooth programmed, but number of tools equals zero
%1 = Channel number %2 = Block number, label
For feed per tooth, the number of teeth has to be specified.
Alarm triggered by following cycles: E_TFS, E_DR_BGF, F_TFS.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Enter the number of teeth on the milling tool in the "Tool list" menu.
Clear alarm with the RESET key. Restart part program
© Siemens AG 2005 All Rights Reserved