61105 |
Channel %1 block %2: Milling cutter radius too large |
Parameters: |
%1 = Channel number %2 = Block number, label |
Definitions: |
The diameter of the cutter used is too large for the form to be machined. Alarm triggered by following cycles: SLOT1, SLOT2, POCKET1 to POCKET4, LONGHOLE, CYCLE90. |
Reactions: |
- Alarm display. - Interface signals are set. - NC Start disable in this channel. |
Remedy: Program Continuation: |
- Interpreter stop Either a tool with a smaller radius has to be used or the contour must be modified. Clear alarm with the RESET key. Restart part program |
© Siemens AG 2005 All Rights Reserved