Reactions:
Remedy:
Program Continuation:
Channel %1 Block %2: Tool radius too large
%1 = Channel number %2 = Block number, label
The tool radius is too large for machining. Alarm triggered by following cycles: CYCLE930, CYCLE951, E_CP_CE, E_CP_CO, E_CP_DR, E_PO_CIR, E_PO_REC, F_CP_CE, F_CP_CO, F_CP_DR, F_PO_CIR, F_PO_REC.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Select a smaller tool.
Clear alarm with the RESET key. Restart part program
© Siemens AG 2005 All Rights Reserved