Reactions:
Remedy:
Program Continuation:
NCU link: conflict in bus parameters of NCU %1
%1 = NCU number
Error message of the NCU link module. When the NCU link was powered up, the local NCU (indicated by the alarm) detected a conflict between its timer bus configuration and the configuration of the NCU in the alarm parameter.
- NC not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Check machine data configuration.
Switch control OFF - ON.
© Siemens AG 2005 All Rights Reserved