27240 |
PROFIsafe: DP M not running up, DP info: %1 |
Parameters: Definitions: |
%1 = Current information from the DP interface NCK-PLC There is no DP configuration available to the NCK after the time specified via the MD $MN_PLC_RUNNINGUP_TIMEOUT. |
Reactions: |
- Mode group not ready. - Channel not ready. - NC Start disable in this channel. |
Remedy: |
- Interface signals are set. - Alarm display. - NC Stop on alarm. Increase MD $MN_PLC_RUNNINGUP_TIMEOUT Check the PLC operating status. Check the PLC operating system software version. Delete the F parameterization in the NCK MD. |
Program Continuation: |
Switch control OFF - ON. |
© Siemens AG 2005 All Rights Reserved