Definitions:
Reactions:
Remedy:
Program Continuation:
PROFIsafe: NCK F module MD %1[%2] is not a %3 module
%1 = MD name %2 = MD array index %3 = Module type
The F module parameterized in the specified NCK MD has not been entered as input/ output module in the S7 PROFIBUS configuration.
%3 = INPUT: NCK F parameterization expects INPUT module
%3 = OUTPUT: NCK F parameterization expects OUTPUT module
%3 = IN/OUT: NCK F parameterization expects INPUT or OUTPUT module
- Mode group not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Check the module in the S7 PROFIBUS configuration.
Switch control OFF - ON.
© Siemens AG 2005 All Rights Reserved