PROFIsafe: Number of NCK F modules (%1) <> Number of S7 F modules (%2)

%1 = Number of parameterized NCK F modules

%2 = Number of parameterized S7 F modules

The number of F modules parameterized via the NCK machine data

$MN_PROFISAFE_IN/OUT_ADDRESS is:

Greater than the number of PROFIBUS slaves in the S7 PROFIBUS configuration. Smaller than the number of F modules in the S7 PROFIBUS configuration, greater than the number of F modules known in the S7 PROFIBUS configuration.

-    Mode group not ready.

-    Channel not ready.

-    NC Start disable in this channel.

-    Interface signals are set.

-    Alarm display.

-    NC Stop on alarm.

Check the F parameterization in MD $MN_PROFISAFE_IN/OUT_ADDRESS. Check the F configuration in the S7 PROFIBUS configuration.

Check the parameterized PROFIsafe master address in MD $MN_PROFISAFE_MASTER_ADDRESS and in the S7 PROFIBUS configuration. Switch control OFF - ON.

© Siemens AG 2005 All Rights Reserved