26018
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
Axis %1 setpoint output drive %2 used more than once
%1 = Axis name, spindle number %2 = Drive number
A setpoint has been selected more than once. The machine data 30110 $MA_CTRLOUT_MODULE_NR contains the same value for different axes.
- Mode group not ready.
- The NC switches to follow-up mode.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Please inform the authorized personnel/service department. Avoid dual assignment of the setpoint by correcting 30110 $MA_CTRLOUT_MODULE_NR. Also check the selected bus type $MA_CTROUT_SEGMENT_NR.
Switch control OFF - ON.
1-1158
© Siemens AG 2005 All Rights Reserved