Remedy:
Program Continuation:
Channel %1 block %2 PUTFTOCF command could not be transferred
%1 = Channel number %2 = Block number, label
The cyclic transfer of the PUTFTOCF data block (fine tool compensation) could not be performed because the transfer area is already occupied.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Check the part program, in particular with regard to the other channels. Is a data block being transferred by another channel?
Clear alarm with the RESET key. Restart part program
© Siemens AG 2005 All Rights Reserved