Channel %1 axis %2 reference point approach: zero marker search velocity (MD) is too high

%1 = Channel number

%2 = Axis name, spindle number

The configured zero marker search velocity is too high. The encoder limit frequency is exceeded for the active measuring system.

-    NC Start disable in this channel.

-    Interface signals are set.

-    Alarm display.

-    NC Stop on alarm.

Please inform the authorized personnel/service department. Configure a lower zero marker search velocity $MA_REFP_VELO_SEARCH_MARKER. Check the encoder frequency configuration $MA_ENC_FREQ_LIMIT and $MA_ENC_FREQ_LIMIT_LOW. Set a different referencing mode ($MA_ENC_REFP_MODE != 7).

Clear alarm with the RESET key. Restart part program

© Siemens AG 2005 All Rights Reserved