22062 |
Channel %1 axis %2 reference point approach: zero marker search velocity (MD) is not reached |
Parameters: |
%1 = Channel number |
Definitions: Reactions: |
%2 = Axis name, spindle number The configured zero marker search velocity is not reached. - NC Start disable in this channel. |
Remedy: |
- Interface signals are set. - Alarm display. - NC Stop on alarm. Please inform the authorized personnel/service department. Check active spindle speed limitations. Configure a lower zero marker search velocity $MA_REFP_VELO_SEARCH_MARKER. Check the tolerance range for the actual velocity $MA SPIND DES VELO TOL. Set a different referencing mode $MA_ENC_REFP_MODE != 7. |
Program Continuation: |
Clear alarm with the RESET key. Restart part program |
© Siemens AG 2005 All Rights Reserved