Definitions:
Reactions:
Remedy:
Program Continuation:
Channel %1 block %3 spindle %2 reference mark not found
%1 = Channel number
%2 = Axis name, spindle number
%3 = Block number, label
When referencing, the spindle turned through a greater distance than given in the axis-specific machine data 34060 REFP_MAX_MARKER_DIST, without receiving a reference mark signal. The check is performed for spindle positioning with SPOS or SPOSA when the spindle has not previously run with speed control (S=...).
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Please inform the authorized personnel/service department. Check and correct the machine data 34060 REFP_MAX_MARKER_DIST. The value entered states the distance in [mm] or [degrees] between 2 zero markers.
Clear alarm with the RESET key. Restart part program
© Siemens AG 2005 All Rights Reserved