Reactions:
Remedy:
Program Continuation:
Error during output of cam signals via timer
The signal output activated by the MD 10480 SW_CAM_T IMER_FASTOUT_MASK via the hardware timer (independent of the clock grid) did not work. Cause: interpolation cycle is greater than 15 ms.
The alarm can be reprogrammed in the MD ALARM_REACTION_CHAN_NOREADY (channel not ready).
- Mode group not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
- Channel not ready.
Please inform the authorized personnel/service department. Shorten interpolation cycle (if at all possible).
Switch control OFF - ON.
© Siemens AG 2005 All Rights Reserved