Definitions:
Reactions:
Remedy:
Program Continuation:
Channel %1 block %3 axis %2 measurement not possible
%1 = Channel number
%2 = Axis name, spindle number
%3 = Block number
Measurement level 2 (MEASA, MEAWA, MEAC).
There is an error in the programmed measurement task.
Possible causes:
Invalid measurement mode Invalid probe Invalid encoder
Invalid number of measurement signal edges
Identical measurement signal edges are only programmable in mode 2 Invalid FIFO number
Mismatch between the number of FIFOs programmed and the number of probes used in the measurement task.
Further causes:
A measurement task is already active (e.g. from a synchronized action).
- Local alarm reaction.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Correct the measurement tasks.
Clear alarm with the RESET key. Restart part program
© Siemens AG 2005 All Rights Reserved