21617
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
Channel %1 block %2 transformation does not allow to traverse the pole
%1 = Channel number %2 = Block number, label
The preset curve passes through the pole or a forbidden area of the transformation.
- Local alarm reaction.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Modify part program (if alarm has occurred in AUTO mode).
To escape from the alarm position, transformation must be deselected (it is not enough to try a RESET if the transformer remains active when RESET is applied).
Clear alarm with the RESET key. Restart part program
1-1057
© Siemens AG 2005 All Rights Reserved