20140 |
Channel %1 motion synchronous action: traversing of command axis %2 see NC alarm %3 |
Parameters: |
%1 = Channel number %2 = Axis %3 = NC alarm |
Definitions: |
An NC alarm was detected for a command axis which is to be traversed from a synchronous action. The NC alarm is indicated by an MMC alarm number in the 3rd parameter. |
Reactions: |
- NC Start disable in this channel. |
Remedy: Program Continuation: |
- Interface signals are set. - Alarm display. - NC Stop on alarm. See help information for the additional alarms. Clear alarm with the RESET key. Restart part program |
© Siemens AG 2005 All Rights Reserved
1-1028