20100 |
Channel %1: invalid configuration for digitizing |
Parameters: Definitions: |
%1 = Channel number The digitizing function expects the definition of three geometry axes in the channel. At the available baud rate for a transmission of the actual positions and setpoint velocities between the NC and the digitizing device, the interpolation cycle must be set to a minimum of 5ms. |
Reactions: |
- Interface signals are set. - Alarm display. |
Remedy: |
Please inform authorized personnel / the service department. Define three geometry axes for the digitizing channel by means of machine data. Use an interpolation cycle greater than 5ms. |
Program Continuation: |
Switch control OFF - ON. |
© Siemens AG 2005 All Rights Reserved
1-1012