Definitions:
Reactions:
Remedy:
Program Continuation:
Channel %1 axis %2 programmed position is behind software limit switch %3
%1 = Channel number %2 = Axis number %3 = "+" or "-"
The axis is traversed as an oscillating axis and the target position (reversal position or end position) is located behind the corresponding software limit switch. The axis is not traversed.
- Local alarm reaction.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Specify smaller target position.
Modify MD for SW limit switch.
Possibly activate another SW limit switch.
Clear alarm with the RESET key. Restart part program
© Siemens AG 2005 All Rights Reserved