Channel %1 axis %2 oscillating - mode change not possible

%1 = Channel number %2 = Axis number

The axis is performing an oscillating movement. Mode change is not possible because oscillation is not allowed in the selected mode.

-    NC Start disable in this channel.

-    Interface signals are set.

-    Alarm display.

-    NC Stop on alarm.

Please inform the authorized personnel/service department. Do not initiate mode change. Cause the PLC to check the axis and make sure in the PLC program that the axis ends oscillation if such mode changes take place.

Clear alarm with the RESET key. Restart part program

© Siemens AG 2005 All Rights Reserved