Definitions:
Reactions:
Remedy:
Program Continuation:
Channel %1 block %2 revolutional feedrate for axis/spindle %3 is <= zero
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
Revolutional feed has been programmed for an axis/spindle, but the velocity was not programmed or the programmed value is smaller than or equal to zero.
- Correction block is reorganized.
- Local alarm reaction.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Please inform the authorized personnel/service department.
Correct the part program or
Specify the correct feed for PLC axes at the VDI interface,
Specify feed for oscillating axes in the setting data $SA_OSCILL_VELO.
Clear alarm with the RESET key. Restart part program
© Siemens AG 2005 All Rights Reserved