17640 |
Channel %1 block %2 spindle operation for transformed axis %3 not possible |
Parameters: |
%1 = Channel number %2 = Block number, label |
Definitions: |
%3 = Axis name, spindle number The axis programmed for the spindle operation is involved in the current transformation as geometry axis. This is not allowed. |
Reactions: |
- Correction block is reorganized. - Interface signals are set. - Alarm display. |
Remedy: Program Continuation: |
First switch off the transformation function. Clear alarm with NC START or RESET key and continue the program. |
© Siemens AG 2005 All Rights Reserved