Reactions:
Remedy:
Program Continuation:
Channel %1 block %2 tool not existing
%1 = Channel number %2 = Block number, label
If an attempt is made to access a tool that has not or not yet been defined, via T no., tool name, or tool name and duplo number, e.g. if tools shall be positioned in magazine locations via programming of $TC_MPP6 = 'toolNo'. It will only be possible, if both the magazine location and the tool determined by 'toolNo' have been defined.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Correct the NC program.
Clear alarm with NC START or RESET key and continue the program.
© Siemens AG 2005 All Rights Reserved