Reactions:
Remedy:
Program Continuation:
Channel %1 block %2 the active tool is no longer on toolholder no./spindle no. %3, program %4
%1 = Channel number %2 = Block number, label %3 = Toolholder no., spindle no.
%4 = Program name
The tool at the specified toolholder/spindle at which the last tool change was carried out as master toolholder or master spindle, has been replaced.
Example:
N10 SETHTH(1)
N20 T="Wz1" ; Tool change at master toolholder 1 N30 SETMTH(2)
N40 T1="Wz2" ; Toolholder 1 is only a secondary toolholder.
Changing the tool does not result in correction deselection.
N50 D5; New correction selection. At present, there is no active tool which D can refer to, i.e. D5 refers to T no. = 0, which results in zero correction.
- Interface signals are set.
- Alarm display.
Modify program:
Set desired spindle as master spindle or toolholder as master toolholder.
Then, if required, reset master spindle or master toolholder.
Clear alarm with the Delete key or NC START.
© Siemens AG 2005 All Rights Reserved