17182
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
Channel %1 block %2 illegal sum correction number
%1 = Channel number %2 = Block number, label
An attempt was made to access a non-defined total offset of the current tool edge.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Access the total offset memory with $TC_SCP*, $TC_ECP*, check the total offset selection DLx or tool selection Ty or offset selection Dz.
Clear alarm with NC START or RESET key and continue the program.
1-907
© Siemens AG 2005 All Rights Reserved