Reactions:
Remedy:
Program Continuation:
Channel %1 action %2<ALNX> only possible in reset state or at the block end
%1 = Channel number
%2 = Action number/action name
This action may only be performed in Reset state or at end of block.
In JOG mode, no axis that is traversed as geometry axis in the switched coordinate system, must be active as PLC or command axis (started through static synchronized action) on mode change. This means that axes like that must be in the state 'neutral axis' again.
- Alarm display.
Check the program status and channel status.
Check in JOG mode whether the axes are PLC or command axes.
Clear alarm with the Delete key or NC START.
© Siemens AG 2005 All Rights Reserved