Definitions:
Reactions:
Remedy:
Program Continuation:
Channel %1 block %2 curve table %3 does not exist for axis %4
%1 = Channel number %2 = Block number, label %3 = Number of curve table %4 = Axis name, spindle number
An attempt was made to couple axis %4 with curve table number %3, but no curve table of this number exists.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Modify the NC part program so that the required curve table exists when axis link is to be activated.
Clear alarm with the RESET key. Restart part program
© Siemens AG 2005 All Rights Reserved